You are currently here: News » Industry » Free technical advice from industry experts at ANTEC ...
Section: General
  • Written on 12.04.2011 - Industry
  • You have these options:
    • Print this article
    • Article as PDF

Free technical advice from industry experts at ANTEC Consultants Corner

A program at the Society of Plastics Engineers (SPE) ANTEC 2011 conference will give attendees an opportunity to consult with an expert—for free—on the challenges they face in specific technical areas. Attendees can register for the appointments-only program, called “Consultants’ Corner,” at the ANTEC website, www.antec.ws. Each appointment will last 30 minutes.

ANTEC 2011, the world’s largest plastics technical conference, will take place May 1-5 in Boston, MA. The Consultants’ Corner schedule, with topics and industry experts, is as follows:

 

Monday, May 2: 3 p.m.-5 p.m.
Blown Film: Gregory Campbell, Castle Research Associates
Single-Screw  Extrusion: Mark Spalding, The Dow Chemical Company
Single-Screw Extrusion:  Tim Womer, TWWomer Associates
Injection Molding:  Lih-Sheng (Tom) Turng, University of Wisconsin-Madison

Tuesday, May 3: 10 a.m.-12 noon
Blown Film:  Gregory Campbell, Castle Research Associates
Failure Analysis & Prevention:  Paul Gramann, The Madison Group
Coextrusion:  Eldridge Mount, Emmount Technologies, LLC
Single-Screw Extrusion:  Mark Spalding, The Dow Chemical Company
Single-Screw Extrusion:  Tim Womer, TWWomer Associates  
Thermoforming:  Roger Kipp, McClarin Plastics

Tuesday, May 3: 3 p.m.-5 p.m.
Blow Molding:  Lew Ferguson, Parisons
Coextrusion:  Eldridge Mount, Emmount Technologies, LLC
Single-Screw Extrusion:  Tim Womer, TWWomer Associates
Thermoplastic Materials & Foams:  Hani Naguib, University of Toronto
Thermoforming:  Roger Kipp, McClarin Plastics

Wednesday, May 4: 9 a.m.-11 a.m.
Blow Molding:  Lew Ferguson, Parisons
Coextrusion:  Eldridge Mount, Emmount Technologies, LLC
Failure Analysis and Material Selection:  Jeffrey Jansen, The Madison Group
Single-Screw Extrusion:  Mark Spalding, The Dow Chemical Company
Thermoforming:  Roger Kipp, McClarin Plastics

 

“The Consultants' Corner provides a fast and convenient way to discuss current issues with industry experts, who will provide candid opinions on topics such as troubleshooting, equipment options, and best practices,” said Mark Spalding, ANTEC 2012 Technical Program Committee Chair.


RSS Feed

Are you new here? Do you want to be always up to date?
Then subscribe to our RSS Feeds and never miss a news again.